GReddy AIR INTAKE SYSTEMS: Honda Civic Si 2006-11 - Manual

Installation
Kit P/N:
12559002 (Polished)
Make:
Honda
Model: Year: Engine:
Civic Si (FG/FA) ’06-’11 L4-2.0L vtec
1
Complete Stock intake. Please disconnect battery
terminals before installation. Do not attempt to install
kit if vehicle is not cold!
2
With 10mm socket or wrench, loosen the 2 bolts secur-
ing the stock air box.
3
Remove crank case line attached with throttle body
coolant line. Have a shop towel or rag handy to catch
any leaking coolant. Use pliers to remove both lines.
Save small clamps for later install.
Caution: Coolant may leak from line when removing!
7
Replace throttle body coolant line with 5/16” hose
provided and secure with clamps used from step 7.
8
Remove MAF sensor from stock air box using phillips
screwdriver.
9
Disconnect MAF sensor harness.
4
Loosen the clamps on stock intake tube using 10mm
socket. Pull back vacuum line and crank case from
intake tube.
5
Remove complete stock air box out of vehicle including
intake tube.
6
06-80499 Pg1
Parts Identification:
1 Air filter ( Pro Dry S™ 61-90130)
1 Intake tube, 05-T1004P1 (Polished)
1 Coupling, elbow 05-00135
2 Clamp #048
1 5/8” hose @ 8-1/2”L
1 5/16” hose @ 18”L
1 Nylon spacer
1 Flat washer M6
1 Nut M6
1 Wavy washer M6
2 Screw M4 x .7 x 8
Tools Required:
10mm socket or wrench
Ratchet w/ extension
Phillips screw driver
Flat head screw driver
5/16” nut driver
Pliers
Note: Perform install only when
engine is cool. Read instructions
before installation and have
tools ready.