GReddy e-Manage: A/F Sensor Harness - Manual

A/F Sensor Harness
《How to Connect》
1. The Yellow connector will be connected to the "Boost" or "Option" port
on the front of the unit.
2. Connect the harness wires to the A/F gauge analog output signal.
※ Please carefully look over the instruction manual for the A/F gauge to
before connecting.
◎This harness is used to read signals from A/F gauge analog outputs.
※Compatible with Support Tool1.20, e-manage1.40 or newer & Emanage Ultimate.
e-manage, e-manage Ultimate
"BOOST"/"OPTION" connector
←
White
Gray
A/F gauge analog (+) output
Use connectors or solder
A/F gauge analog (-) output
A/F Sensor Harness
《How to Connect》
1. The Yellow connector will be connected to the "Boost" or "Option" port
on the front of the unit.
2. Connect the harness wires to the A/F gauge analog output signal.
※ Please carefully look over the instruction manual for the A/F gauge to
before connecting.
◎This harness is used to read signals from A/F gauge analog outputs.
※Compatible with Support Tool1.20, e-manage1.40 or newer & Emanage Ultimate.
e-manage, e-manage Ultimate
"BOOST"/"OPTION" connector
←
White
Gray
A/F gauge analog (+) output
Use connectors or solder
A/F gauge analog (-) output