GReddy Profec - Manual (Page 14)

■Twin Turbo Vehicles■
1
2
Installing the solenoid valve unit ‒ (Twin Actuator Type)
Actuators
Turbo compressor
pressure sources
Installation
For twin turbo applications, two Y connectors will be required. However, the
installation procedure is the same as Page 12. Place a Y connector to connect the
[1] port of the solenoid valve to the two ports for Turbine compressor as shown in
the diagram above. The same applies for the [2] port of the solenoid valve, use a Y
connector to connect the two wastegate actuators.