GReddy AIR INTAKE SYSTEMS: Mitsubishi Lancer 2008-12 - Manual

Installation
Kit P/N:
12539001 (POLISHED)
Make:
Mitsubishi
Model: Year: Engine:
Lancer ‘08-’12 L4-2.0L
1
Complete stock intake. Please disconnect battery
terminals before installation.
2
Disconnect MAF sensor and pull back crank case line
and remove from engine.
3
With t20 torx bit screwdriver remove MAF sensor from
air box.
7
Install MAF sensor to new tube and secure using M4
screws provided.
8
Tighten isolation mount provided on housing using
10mm socket or wrench.
9
With 10mm socket or wrench loosen the clamp on
throttle body. Unclip upper half air box and remove
intake assembly.
4
With 10mm socket or wrench loosen bottom half of air
box. Pull back harness clip from air box.
5
Pull back ram air assembly from air box and remove.
6
06-80501 Pg1
Parts Identification:
1 Air filter ( ™ 61-90132)
1 Intake tube, polished 05-T4201P1
1 Housing, wrinkle black 05-T4201B2
1 Coupling, elbow 05-00135
2 Clamp #048
2 Wavy Washer M6
2 Flat washer M6
2 Nut M6
1 Nylon spacer
2 Screws M4
1 1/2” hose @ 6”L
2 Screws M6
Tools Required:
10mm socket or wrench
Ratchet w/ extension
Phillips screw driver
Flat head screw driver
5/16” nut driver
4mm allen key
Pliers
Note: Read instructions before
installation and have tools ready.