Troubleshooting, Maintenance – JKS 2034 User Manual

Page 6

JKS2030 - JKS2034

JKS Quicker Disconect Installation

Page A

7. CORRECT OPERATION OF QUICKER

DISCONNECTS

Remove the Click Pins (J) from the Upper and

Lower Tapered Mounting Posts (C, K & M).

Completely remove Quicker Disconnects from

vehicle and store safely inside vehicle. HINT:
To avoid losing Click Pins, reinstall them on
mounting posts while Quicker Disconnects are
removed.

Using plastic wire ties, bungee cord or equivalent,

secure the swaybar to the chassis in the horizontal
position.

IMPORTANT: When disconnected, the swaybar
must be secured in the horizontal position to pre-
vent interference with the tires. Failure to secure
the swaybar correctly can lead to severe tire dam-
age.

To reconnect, remove Click Pins (J) from mounting

posts and rotate swaybar down.

Slide Quicker Disconnects back onto mounting

posts and reinstall Click Pins. HINT: Install pas-

senger side Quicker Disconnect first for easiest
reinstallation.

JKS Technical Support

Phone

517-278-1226

E-Mail

[email protected]

Troubleshooting

If swaybar does not rotate freely, remove from vehicle,
clean and apply rubber lubricant to chassis-mounted
bushings, and reinstall.

Maintenance

It is important to lubricate Quicker Disconnects fre-

quently for the first three (3) months after installation
to evacuate contaminants that may build up during
break-in period.

After break-in period, Quicker Disconnects should be
lubricated regularly as part of vehicle maintenance
schedule.

Regular cleaning with pressurized water is recom-
mended to maximize ease of operation and reliability.
Always lubricate afterwards to evacuate any moisture.

This manual is related to the following products:

2030