Installation – JKS 2034 User Manual
Page 3
JKS2030 - JKS2034
JKS Quicker Disconect Installation
Page 3
must be secured to prevent interference with other
suspension components.
Brakelines must be secured and retain some slack
throughout range of suspension travel. Check after
installation of Quicker Disconnects™ & use longer
DOT approved brakelines if necessary.
Installation
1. REMOVE ORIGINAL EQUIPMEN (OE)
SWAYBAR LINKS
Remove front swaybar drop links and mounting
hardware per the factory service manual instruc-
tions for your vehicle.
2. INSTALL UPPER MOUNTING POSTS
Locate the long stainless steel 1/2" Upper Tapered
Mounting Posts (C) with attached Offset Polyure-
thane Spacers (B).
Mount the Upper Tapered Mounting Posts (C) on
outboard side of the swaybar, ensuring small Click
Pin holes are horizontal or parallel with the ground.
Apply medium strength threadlocker to the tip of
mounting post threads.
Secure mounting posts to swaybar by installing
1/2" Nylock Nuts (A) from the inboard side and
tighten to 65 ft-lb. using a torque wrench.
HINT:
A small Philips head screwdriver or punch
inserted into the Click Pin hole will enable you to pre-
vent the mounting post from rotating when tightening
the nut.