EOTech LWTS Light Weapon Thermal Sight - Manual (Page 29)

2-11
2.7 POWER
Power On
Pressing the ON/OFF/STANDBY button will initiate an
approximate 3 second warm-up period, after which the
LWTS display turns on. The LWTS will power up with the
same settings selected as when the system was last turned
off, except that:
a. CAL is set to AUTO CAL ON (see section 2.19)
b. FOV is set to WFOV (see section 2.14)
c. AGC is set to AGC ON (see section 2.11)
d. Reticle mode is set to ARC (see section 2.20)
e. Video I/O is set to I/O OUT (see section 2.23)
Standby Mode
NOTE
In Standby Mode, the LWTS will continue to draw
power that will eventually drain the batteries. Turn
off the unit if it is not expected to be used.
With the system powered on, the LWTS can be placed in a
Standby Mode for purposes of light discipline, as follows:
1. Press and hold the ON/OFF/STANDBY button. The
following messages will sequentially appear in the
display:
a. STANDBY?
b. STANDBY!
2. When the STANDBY! message is displayed (about 2
seconds), release the ON/OFF/STANDBY button. The
LWTS is now in Standby Mode.