EOTech LWTS Light Weapon Thermal Sight - Manual (Page 23)

2-5
2.3 STAND-ALONE MOUNTING INSTRUCTIONS
(Continued)
NOTE
The LWTS may be placed at any position (forward
and aft) on the rail that is most convenient for the
operator. If, however, the LWTS is removed from
the rail, the operator should note the position at
which it was zeroed, and return it to that same
position to ensure that zero is retained.
1. Pull the lever lock out to the full open position.
2. Swing the throw-lever toward the front (objective lens) of
the LWTS to allow the mounting bracket sufficient space
to fit over the MIL-STD-1913 rail.
3. Position the mounting bracket over the rail ensuring that
the recoil lug is properly seated in the desired recoil
groove of the rail.
CAUTION
If too much or too little force is required to perform
step 4, the throw-lever must be adjusted to
properly secure to the rail of the host weapon.
See section 3.3 for adjustment procedures.
4. While pushing down and forward on the LWTS, swing the
throw-lever toward the back (eyepiece) of the LWTS until
it is snug against the mounting bracket.
5. Push the lever lock in to engage the locking mechanism.