EOTech Target Pointer Illuminator Aiming Light - Manual (Page 59)

2-35
NOTE
Failure to fully tighten the Training Extender
thumbwheel screw and AN/PEQ-2A thumbscrew
may cause zero retention problems.
a. Mount brackets to the M16A2, M4/M4A1 or M4
MWS per instructions provided previously.
b. Attach Training Extender to the appropriate brackets
and securely tighten using the thumbwheel screw.
c. Mount the AN/PEQ-2A to the Training Extender
Bracket as shown in Figure 2-20. Turn the
thumbscrew clockwise to tighten. Use a screwdriver
or similar tool in the slot of the thumbscrew to fully
secure the AN/PEQ-2A to the bracket.
d. Install the Remote Cable Switch in a convenient
location (see paragraph 2.5.3).
Figure 2-20 M16A2 Using MILES Training Extender
Bracket and M4/M16A2 Bracket