Boonton 52000 Series USB CW Power Sensor - Manual (Page 9)

Boonton 52000 Series
1 Installation Of Software
This chapter provides information about installing the Boonton
power sensor/meter software.
Before you start, please check your PC for software compatibility.
Refer to “Minimum PC requirements” on page 63 for more
information.
Install procedure
To install the Boonton software, follow these steps:
Caution Do not connect any hardware to your PC until you have
installed the Boonton software.
Note If you are using Windows XP SP1, disconnect any LAN
connections. This will prevent your PC automatically downloading
the wrong USB drivers.
Do this Comment
1. Insert the CD into your PC The installation should start automatically.
2. (Optional) If the installation
does not start automatically,
select Start > Run and type
d:\BoontonSensorInstallation.exe Where D:\ is the name of your CD drive.
3. Select Continue Refer to Figure 2 on page 10.