Boonton 52000 Series USB CW Power Sensor - Manual (Page 21)

Boonton 52000 Series 21
Hardware Connections
This chapter provides an overview of how to connect your 52000 CW
power sensor/meter in your test environment.
How to connect your sensor
The section describes some typical connection configurations.
Connection to your PC
Connection to your PC is through a USB cable (supplied with
your sensor). The 52000 series CW Power sensor/meter is USB 2.0
compatible. It is recommended that you use the USB cable supplied
with your sensor. Refer to Figure 15 “Sensor to PC connection” on
page 21 for a diagram of the sensor and PC connection.
Figure 15 Sensor to PC connection
The maximum recommended connection length is 5m.
USB Cable
Your PC
52000 Sensor
52012 CW Power Sensor
ESD
Earth ground must be connected Max pwr +23dBm avg, +30dBm peak for 1us +/- 10.0VDC Max.
10MHz - 12.4GHz
10nW - 100mW (-50dBm to 20dBm)