Boonton 52000 Series USB CW Power Sensor - Manual (Page 13)

Boonton 52000 Series 1
2 USB Installation
This chapter explains the process for installing and enabling the USB
drivers for your 52000 series CW power sensor/meter. These drivers
are required to enable effective measurement data Transfer.
There are two USB driver installation procedures covered in this
chapter – one for Windows® XP SP1 and the other for Windows® XP
SP2. To identify which operating system you have on your PC, refer to
“How to identify your PC operating system” on page 55.
Driver installation with Windows® XP SP2
This section describes how to install and configure your USB drivers
on a PC with Windows® XP and service pack 2 (SP2) operating
system.
Caution Do not connect your sensor and install the USB drivers
unless you have installed the Boonton software. Refer to “Installation
Of Software” on page 9 for more information.
1. Connect your sensor to the USB port of your PC. The Windows
Hardware Wizard starts automatically.
Refer to “How to connect your sensor” on page 21 for more
information.
2. Choose “No not at this time” and select Next.
Refer to Figure 7 on page 14.