Load a roll into the printer, Easy loading procedure – HP Designjet Z3100 Photo Printer series User Manual
Page 37
6.
Put the blue paper stop on to the open end of the spindle, and push it towards the end of the roll.
7.
Ensure the blue paper stop is pushed in as far as it goes; until both ends are against the stoppers.
If you are a regular user of different paper types, you can change rolls more quickly if you preload rolls
of different paper types on different spindles. Extra spindles are available for purchase, see
Load a roll into the printer
There are two ways to load a roll. The easy loading procedure is recommended.
CAUTION
To start these procedures you must have a roll loaded on the spindle. See
roll onto the spindle on page 25
Easy loading procedure
1.
Check that you are using the correct spindle for your type of paper, see
.
2.
Standing behind the printer, rest the spindle's black end on the left side roll holder. Do not put the
end completely into the roll holder.
3.
Rest the blue end of the spindle on the right side roll holder. If you are loading the gray spindle,
ensure the rounded side of the spindle top is resting on the roll holder.
ENWW
Load a roll into the printer
27
Paper handling