beautypg.com

Scanning errors during alignment, Printhead status messages – HP Designjet Z3100 Photo Printer series User Manual

Page 160

background image

3.

If the loaded paper is satisfactory, the printer runs the realignment and prints a realignment pattern.
Ensure the transparent window is closed, as a strong light source near the printer during printhead
realignment can affect alignment.

4.

The process takes about five minutes. Wait until the front-panel display shows the process
complete before using the printer.

Scanning errors during alignment

If the alignment process fails, a Scanning problems message appears on the front panel. This means
that the alignment has not completed successfully. Therefore the printer is not aligned and the alignment
should be repeated before printing with good image quality. The problem may be due to:

The paper used was not valid, repeat the alignment with valid paper

Printhead health problems, clean printheads, see

Clean the printheads on page 145

The alignment was done with the transparent window open, repeat the alignment with the window
closed

If the problem persists after using valid paper, cleaning the printheads, and keeping the window closed,
there may be a failure in the scanning system needing reparation or the printheads, although clean, may
not work and need to be replaced.

Printhead status messages

These are the possible printhead status messages:

OK: the printhead is working normally, with no known problems

Missing: there is no printhead present, or it is not correctly installed in the printer.

Test printhead separately: you are recommended to test the printheads individually to find the
failing printhead. Remove all the printheads and insert them alone one by one, closing the latch
and the carriage lid after every insertion. The front-panel display indicates the failing one showing
the reseat or replace message.

Reseat: you are recommended to remove the printhead and then reinsert it. If that fails, clean the
electrical connections, see

The front-panel display recommends reseating or replacing a

printhead on page 145

. If that fails, replace the printhead with a new printhead, see

Remove a

printhead on page 88

and

Insert a printhead on page 91

.

Replace: the printhead is failing. Replace the printhead with a working printhead, see

Remove a

printhead on page 88

and

Insert a printhead on page 91

.

Replacement incomplete: a printhead replacement process has not completed successfully, re-
launch the replacement process and let it finish completely (it is not needed to change the
printheads).

Remove: the printhead is not a suitable type for use in printing.

150 Chapter 13 Troubleshooting ink cartridge and printhead issues

ENWW

Troubleshooting ink

cartridg

e and

p

rin

th

ead

issues