HP Designjet Z3100 Photo Printer series - Manual (Page 17)

7. Cancel key - To abort a procedure or interaction.
8. Power key - To turn the printer off or on, it also has a light to indicate the printer's status. If the
power key light is off the device is off. If the power key light is blinking green, the device is starting
up. If the power key light is green on, the device is on. If the power key light is amber on, the device
is in standby. If the power key light is blinking amber, the device needs attention.
9. LED light - Indicates the printer's status. If the LED light is solid green, the device is ready. If it is
flashing green, the device is busy. If it is solid amber, there is a system error. If it is flashing amber,
the printer needs attention.
10. Front-panel display - Displays error, warnings, and information on using your printer.
To highlight an item in the front-panel display, press the Up or Down key until the item is highlighted.
To select an item in the front-panel display, first highlight it and then press the OK key.
When this guide shows a series of front-panel display items like this: Item1 > Item2 > Item3, it means
that you should select Item1, then select Item2, then select Item3.
Information about specific uses of the front panel can be found throughout this guide.
Printer software
The following software is provided with your printer:
● The PCL3 raster driver, your main printer driver
● The HP Easy Printer Care (Windows) or HP Printer Utility (Mac OS), see Access HP Easy Printer
Care (Windows) or HP Printer Utility (Mac OS) on page 19 , allows you to:
● Manage the printer including color with the HP Color Center
● View the status of the ink cartridges, the printheads, and the paper
● View job accounting information, see Retrieving printer usage information on page 79
● Update the printer's firmware, see Update the firmware on page 102
● Change various printer settings (in the Settings tab)
NOTE Windows XP Professional x64 Edition does not support HP Easy Printer Care,
therefore it cannot be installed by your printer's installer.
● The Embedded Web Server, runs in the printer and enables you to use a Web browser on any
computer to perform the HP-GL/2 Upgrade and to check ink levels and printer status, see
Access
the Embedded Web Server on page 19 .
● The RTL and HP-GL/2 driver for Windows, needed if you have the HP-GL/2 Upgrade
The printer's internal prints
The internal prints give various kinds of information about your printer. They can be requested from the
front panel without using a computer.
CAUTION Before requesting any internal print, make sure that paper is loaded (roll or sheet),
and that the front panel displays the Ready message. The loaded paper should be at least A3
landscape (16.53 in or 42 cm wide); otherwise the print may be clipped.
ENWW Printer software 7
Intr
oduction