HP Designjet Z3100 Photo Printer series - Manual (Page 36)

2. The spindle has a stop at each end to keep the roll in position. The blue stop can be removed to
mount a new roll; it slides along the spindle to hold rolls of different widths. Remove the blue paper
stop from the end of the spindle.
3. If your roll has a three-inch cardboard core, ensure that the core adaptors supplied with the printer
have been installed.
4. If the roll is long; rest the spindle horizontally on a table and load the roll on the table.
Tip You may need two people to handle a large roll.
5. Slide the new roll onto the spindle. Make sure the paper type is oriented as shown. If it is not,
remove the roll, turn it 180 degrees and slide it back on to the spindle. There are labels on the
spindle showing the correct orientation.
NOTE From the back of the printer, the blue stopper is insert into the right-side holder.
Ensure both ends of the roll are as close to the spindle stops as possible.
26 Chapter 4 Paper handling ENWW
P
ape
r ha
ndl
ing