HP XP P9500 Storage - Manual (Page 62)

Table 20 RAID Manager Error Codes (continued)
Description SSB2 code
The create pair operation was rejected because the volume specified as the primary volume had
already had three secondary volumes. 2326
The create pair operation was rejected because the node volume specified as the primary volume
had already had two secondary volumes. 2327
The pair operation was rejected because the pair configuration exceeded the number of the layers
of the cascade configuration. 2328
The pair operation was rejected because the volume specified as the secondary volume was the
secondary volume of an existing pair. 2329
The create pair operation was rejected because pairs that would exceed the license capacity were
going to be created. 232a
The pair operation was rejected because the volume specified as the primary volume was allocated
as the destination of the Auto LUN. 232F
The pair operation was rejected due to one of the following causes. 2331
• The volume specified as the primary volume was a reserved volume.
•
The volume specified as the primary volume was the volume for Auto LUN.
•
The capacity of the specified primary volume and the secondary volume was not the same.
The create pair operation was rejected because the volume specified as the primary volume had
already had three secondary volumes. 2332
The pair operation was rejected because the volume specified as the primary volume was not the
primary volume of the existing pair. 2333
One of the following occurred: 2334
• The pair operation was rejected because the volume specified as the primary volume had an
emulation type that could not be handled by RAID Manager.
•
The consistency group split operation was rejected because the volume specified as the primary
volume was an intermediate volume.
The pair operation was rejected because the volume specified as the secondary volume had an
emulation type that could not be handled by RAID Manager. 2335
The pair operation was rejected because the emulation type of the specified primary volume was
different from the emulation type of the secondary volume. 2336
One of the following occurred. 2337
• The pair operation for the cascade configuration was rejected because the volume specified as
the primary volume was an intermediate volume.
•
The pair operation was rejected because the specified primary and secondary volumes were LUSE
volumes, and the number of volumes composing the primary volume did not match the number of
volumes composing the secondary volume.
The pairresync was rejected because the volume specified as the primary volume was not a BC primary
volume. 233A
The pair operation was rejected because the volume specified as the secondary volume was a root
volume. 233B
The pair operation was rejected because the volume specified as the secondary volume was a node
volume, and the volume specified as the primary volume was not the primary volume for the specified
secondary volume. 233C
The pairsplit was rejected because the specified primary and secondary volumes were a L2 pair, and
the L1 pair status was not PSUS. 233D
The pair operation was rejected because the volume specified as the primary volume was used as
the Cnt Ac-S P-VOL. 233E
62 Troubleshooting