HP 6Gb SAS Switch for HP BladeSystem c-Class - Manual (Page 66)

Success
NOTE: Entering a range of port numbers is not supported. Each port must be entered,
separated by a comma.
3. [Optional] Verify that the zone group was created as intended.
For example, use one of the following commands:
=> switch loc=local port all show detail
=> switch loc=local zg OpenZone show
The display of this example is abbreviated, retaining key details. The display shows information
for the switch installed in interconnect bay 5, and that port 4 is included in zone group named
Ports_1.
=> switch loc=local port all show detail
Blade Enclosure At BottomC7000
Switch: Local (VSM Active)
Blade Switch Port: 54(Ports_1)
Port Number: 1
Zoning Status: OK
Presence: Present
Attached Device Type: SAS Controller
Product ID: P2000 G3 SAS
Attached Device Firmware Version: T230
Enclosure Logical ID: 500C0FFDAC0A5000
LED Status: Green
Zone Group: Ports_1
Blade Switch Port: 55(Not Zoned)
Port Number: 2
Zoning Status: OK
Presence: Absent
LED Status: Off
.
.
.
66 Performing common tasks