HP 6Gb SAS Switch for HP BladeSystem c-Class - Manual (Page 35)

5 Tasks in the VSM Maintain tab
After selecting a device in the navigation tree, a task list for that device is displayed.
NOTE: If a task is listed, but cannot be selected, system status conditions are not acceptable for
that task to be performed. When this occurs, the cause is listed, so corrective action can be taken.
The following table lists the available tasks.
Where documented Available tasks System component
“Capture Configuration task” (page 36) Capture Configuration HP 6Gb SAS Blade Switch
(VSM Active)
“Input Configuration task” (page 36) Input Configuration
“Update SAS Switch Firmware task” (page 36) Update SAS Switch
Firmware
“Reset Hardware task” (page 41) Reset Hardware
“Reset Software task” (page 41) Reset Software
“Update Storage Enclosure Firmware task” (page 41) Update Storage Enclosure
Firmware
“Reset Storage Enclosure task” (page 44) Reset Storage Enclosure
“Network Settings task” (page 45) Network Settings
“SNMP Settings task” (page 45) SNMP Settings
“SNMP Test Trap task” (page 45) SNMP Test Trap
“Force VSM Active task” (page 46) Force VSM Active
“VSM Event Log task” (page 46) VSM Event Log
“Clear VSM Event Log task” (page 47) Clear VSM Event Log
“Diagnostic Log task” (page 47) Diagnostic Log
More Information
Topology Map
“Unit ID Light task” (page 47) Unit ID Light Storage Enclosure
“Replicate Zoning Configuration task” (page 47) Replicate Zoning
Configuration
“Update Storage Enclosure Firmware task” (page 41) Update Storage Enclosure
Firmware
“Reset Storage Enclosure task” (page 44) Reset Storage Enclosure
More Information
Topology Map
More Information HP 6Gb SAS Blade Switch
(VSM Passive)
Topology Map
35