HP Integrity NonStop H-Series - Manual (Page 67)

Section 4: SCSI Bridge Electronics
If your configuration or NonStop server environment requires unique settings or special
configurations, HP can provide assistance and minor firmware configurations for specific platforms,
software or drives through the use of this menu item. This setting is factory-configured at 00001400
and you should never have to changed it. As noted, special situations may require this setting be
changed, but it is highly recommended that you contact your service provider before changing this
setting. Use the Numeric Entry Method to enter the eight-digit hex value.
2.7.3 Selecting a Baud Rate
BaudRate
9600 bps
PRESS to
Scroll BaudRate
1200 bps
PRESS to
Scroll
BaudRate
9600 bps
PRESS to
Alter
BaudRate
19K2 bps
PRESS if
Done
BaudRate
2400 bps
PRESS to
Scroll
Figure 63 Selecting a baud rate
Four different baud rates are available for connecting to a serial terminal or terminal emulator: No parity, 8
data bits, 1 stop bit, and xon/xoff flow control. The 3-pin serial connector on the tape drive can connect to
a PC serial port by using a communication package such as PRO-COMM (with xon/xoff enabled) to
upgrade the flash firmware. Use the Pick Entry Method to select a baud rate.
2.8 Setup 3 Off-line Utilities Display Format Items
Enter
Set-Up 3
PRESS to
Select
Drive
Test
PRESS to
Run
Exit
Set-Up 3
PRESS to
Select
Load a
CodeTape
PRESS to
Run
Create a
CodeTape
PRESS to
Run
Hdwr
Test
press
to run
Figure 64 Setup 3 off-line utilities menu
HP StorageWorks DAT 72 (Models 5242 and 5242-ACL) User's Guide 60 HP Part Number 528296-03 July 2005