HP Integrity NonStop H-Series - Manual (Page 17)

Section 1: General Information
O l
Fan AC Out
Power
Connector
AC In
Power
Connector
Power
Switch
SCSI
Connectors
AC Out
Power
Connector
Blank
Figure 5 5242 subsystem rear panel
O l
Fan SCSI
Connectors
AC In
Power
Connector
AC Out
Power
Connector
Power
Switch
Blank
Figure 6 5242-ACL subsystem rear panel
3.2.3.2 Connecting a SCSI Cable to the Tape Drive FRU
Copper SCSI cables come in lengths ranging from 3 to 25 meters (10 – 82 feet) and do not
require special installation. At the rear of each tape drive FRU, there are two 68-pin SCSI
ports. SCSI cable links. Connect one of these ports to the NonStop S-series server, M8201
Fibre Channel to HVD SCSI router, or S-Series I/O enclosure for use on Integrity NonStop
servers.. A SCSI terminator plugs into the other port. See Figure 9. Connect the SCSI cable
to the SCSI port on the tape drive:
1. Locate the SCSI cable.
2. Align the 68-pin SCSI cable connector, which has thumb screw connectors, with the
uncapped SCSI port on the top as you face the rear of tape drive.
3. Attach the 68-pin SCSI cable connector to the SCSI port and secure the thumb screw
connectors. (See Figure 7.)
4. Ensure a SCSI terminator is firmly installed one of the two SCSI ports.
HP StorageWorks DAT 72 (Models 5242 and 5242-ACL) User's Guide 10 HP Part Number 528296-03 July 2005