HP Virtual Connect Flex-10 10Gb Ethernet Module for c-Class BladeSystem - Manual (Page 100)

Configuring the Virtual Connect domain using the CLI 100
(and update their MAC caches appropriately.) This transmission sequence repeats a few times at the MAC
refresh interval (5 seconds recommended) and completes in about 1 minute.
IMPORTANT: Be sure to set switches to allow MAC addresses to move from one port to another
without waiting for an expiration period or causing a lock out.
Logging out of the CLI
To log out of the CLI, use the exit command:
>exit
Common management operations
The following table provides the syntax for the most commonly used management operations.
For detailed information on a particular command, see "Managed elements (on page
13 )."
Operation Examples
Display general domain settings
>show domain
Display predefined address pools
>show domain addresspool
Display interconnect modules • Summary display
>show interconnect
• Detailed display
>show interconnect *
• Single module display
>show interconnect enc0:2
Display overall domain status
>show status
Display stacking link configuration and status >show stackinglink
Display the system log
>show systemlog
Display a list of servers in the domain • Summary display
>show server
• Detailed display
>show server *
• Single server display
>show server enc0:1
Display server profiles • Summary display
>show profile
• Detailed display
>show profile *
• Single profile display
>show profile MyProfile
Delete the domain configuration
>delete domain
Force a failover to the standby VC Manager
>reset vcm - failover
Power off server blades
>poweroff server enc0:2
>poweroff server *
Power on server blades
>poweron server enc0:1
>poweron server *
Reset a server blade
>reboot server enc0:4