HP StorageWorks XP Remote Web Console Software - Manual (Page 99)

LUN Configuration and Security Manager XP user guide for the XP12000/XP10000/SVS200 99
Configuring Fibre Channel ports
Use the Port pane ( Figure 21 ) to configure Fibre Channel ports in the array. You can also use this pane to
modify the port configuration when the system is operating.
NOTE: You cannot configure Fibre Channel ports and perform operations related to NAS channel
adapters at the same time. Therefore, when you perform operations on a NAS channel adapter first in the
Port pane, you cannot configure Fibre Channel ports. Click Apply once to apply changes to the array,
and then configure the Fibre Channel port.
Specifying Fibre Channel topologies
The term topology refers to how devices are connected to each other. For more information, see ” Fibre
Channel topologies ” on page 25.
1. Start LUN Manager, and display the Port pane ( Figure 21 ).
2. In the Package tree, select the Fibre folder or a Fibre Channel channel adapter.
• If you select the Fibre folder, the Port table displays a list of Fibre Channel ports in the array.
• If you select a channel adapter, the Port table displays a list of Fibre Channel ports on the channel
adapter.
3. In the Port table or Select a Port list, select a port. The Change Port Mode box displays information
about the selected port.
4. If you are using a fabric switch, select Enable in the Fabric list.
If you are not using a fabric switch, select Disable in the Fabric list.
5. In the Connection list, select FC-AL or P-to-P.
NOTE: If you are using a fabric switch, see the fabric switch’s documentation to check if the
fabric switch requires the point-to-point topology. Some fabric switches require the point-to-point
topology to get the system running. To specify the point-to-point topology, select P-to-P.
6. Click Set. A confirmation message appears.
7. Click OK. Settings are applied to the Port table, but not to the array. Changes are indicated in blue.
8. Click Apply. A confirmation message appears.
9. Click OK. Settings are applied to the array.
Addressing Fibre Channel ports
When configuring a system, you must assign addresses to Fibre Channel ports. For more information, see
” Fibre Channel port addresses ” on page 26.
NOTE: For more information about Fibre Channel device addressing, see the array’s documentation.
1. Start LUN Manager, and display the Port pane ( Figure 21 ).
2. In the Package tree, select the Fibre folder or select a Fibre Channel channel adapter.
• If you select the Fibre folder, the Port table displays a list of Fibre Channel ports in the array.
• If you select a channel adapter, the Port table displays a list of Fibre Channel ports on the channel
adapter.
3. In the Port table or Select a Port list, select a port. The Change Port Mode box displays information
about the selected port.
4. In the Fibre Addr. list, select an address.
5. Click Set. A confirmation message appears.
6. Click OK. Settings are applied to the Port table, but not to the array. Changes are indicated in blue.