HP StorageWorks XP Remote Web Console Software - Manual (Page 95)

LUN Configuration and Security Manager XP user guide for the XP12000/XP10000/SVS200 95
5. Click OK. Settings are applied to the array.
Copying paths from a NAS port to a Fibre Channel or iSCSI port
CAUTION: Before taking the following steps, see ” Notes on using LUN Manager ” on page 53 for
important information.
1. Start LUN Manager, and display the LUN Manager pane ( Figure 14 or Figure 15 ).
2. To specify the LU paths you want to copy:
a. In the tree, double-click a NAS port (copy source port), and select the User host group.
b. From the LU Path list, select one or more LUNs to which volumes are assigned. If a volume is
assigned to a LUN, columns on the right of the LUN column are not empty.
c. Right-click the selection, and select Copy Paths. The selected LUNs turn green.
3. To paste the LU paths:
a. Double-click the Fibre Channel or iSCSI port (copy destination port). Host groups or iSCSI targets
appear below the port.
b. Right-click the host group or iSCSI target to which you want to paste paths, and select Paste Paths.
If a confirmation message appears, click OK.
NOTE: You cannot paste paths to host groups or iSCSI targets for initiator ports.
4. Click Apply. A confirmation message appears.
5. Click OK. Settings are applied to the array.
Viewing a list of alternate paths
1. Start LUN Manager. The LUN Manager pane ( Figure 14 or Figure 15 ) appears.
2. Do either of the following:
• In the LU Path list, right-click a LUN, and select Alternate Paths.
NOTE: If nothing appears in the table cells to the right of a LUN, no path is defined to the LU.
Therefore, no alternative path is defined to the LU.
• In the LDEV table, right-click a logical volume (that is, an LDEV), and select Alternate Paths.
NOTE: If nothing appears in the Paths column for a row in the LDEV list, no alternate paths are
defined to the LDEV corresponding to that table row.