HP Virtual Connect Enterprise Manager Software - Manual (Page 84)

3. Depending on the power status of the bay, perform one of the following steps:
•
If the bay is currently powered down, then proceed to the Assigning a server profile to
a bay procedure section.
•
If the bay is currently powered up, then click Momentary Press, which automatically
powers down the bay.
•
If the bay is currently powered up and clicking Momentary Press does not power down
the bay, then click Press and Hold.
CAUTION: Only use the Press and Hold option when other attempts at powering down the
bay have failed, such as attempting to shut down from the physical bay instead of remotely.
Figure 35 Bay status with tab and hold
Assigning a server profile to a bay
You can assign a server profile to a bay only if the bay is not already associated with a server
profile and if the server is powered down. To assign a server profile to a bay:
1.
Click the Bays tab.
2. (Optional) From the Filter list, select VC Domain or VC Domain Group, and click Filter.
3. Select the bay.
4. Click Assign Server Profile. The Assign Server Profile page appears.
5. Select an unassigned server profile.
6. Click OK. The Virtual Connect Enterprise Manager is executing the request
message appears.
7. Click OK to go to the Jobs page and monitor job progress.
Unassigning a server profile from a bay
You can only unassign a server profile from a bay if the bay is associated with a server profile
and if the server is powered down. To unassign a server profile from a bay:
1.
Click the Bays tab.
84 Managing enclosure bay assignments