HP Identity Driven Manager Software Licenses - Manual (Page 152)

4-16
Using the Secure Access Wizard
Using Secure Access Wizard
Figure 4-12. Secure Access Wizard, RADIUS Servers configuration
The Authentication Servers step lets you enter the IP addresses of the RADIUS
servers to be used for authentication. Most ProCurve devices support three
RADIUS server, but some, such as the wireless products, supports only two.
a. Click the check box for a RADIUS server to enable the server IP
address field, and then enter the IP address for the server.
The IP address will be validated. If it is invalid or a duplicated IP, a
text message indicating the error is displayed. You cannot continue
until a valid IP address is entered.
N o t e : If you had previously configured other RADIUS servers for authentication
with the device, that information will be over-written by the Secure Access
Wizard. The SAW will attempt to remove enough currently configured
RADIUS servers to “make room” for the ones configured in the SAW. So,
if you already have three RADIUS servers configured on a device, and then
the you configure two new RADIUS servers via the SAW, when the settings
are applied the SAW will remove the first two servers from the device
configuration.
16. Click Next to continue to the RADIUS Server Shared Secret window.