ADC HiGain H2TU-C-319 List 4E User Manual
Page 28
Provisioning
LTPH-UM-1049-02, Issue 2
20
January 9, 2002
H2TU-C-319 List 4E
Minor Alarm
ALM
ENA
Enables the generation of the output alarm on pin H when a system alarm
condition occurs.
DIS
Disables the generation of the output alarm on pin H when a system alarm
condition occurs.
Network AIS Signal
NAIS
CI
If ALMP is set to AIS, this option specifies which pattern is sent to the network
when a remote LOS or AIS occurs. When configured for CI, an AIS-CI pattern
is sent to the network.
AIS
When configured for AIS, an AIS pattern is sent to the network.
Performance Report
Messaging
PRM
SPRM
The H2TU-R generates Supplemental PRM (SPRM) every second if no PRM
is received from the CPE within 5 seconds of a reset or if an LOS/AIS/LOF
condition occurs. TL1 commands and responses are enabled.
NPRM
The H2TU-R generates Network PRM (NPRM) if no PRM is present from the
CPE. If the CPE is sending PRMs, NPRM is generated every second in addition
to the existing PRM. TL1 commands and response are enabled.
S + N
The H2TU-R generates an NPRM which is tagged onto an SPRM every
second. The H2TU-R generates SPRM if no PRM is present from the CPE. If
the CPE is sending PRM, the PRM is converted to an SPRM. TL1 commands
and responses are enabled.
OFF
ESF Datalink (DL) is completely transparent. No PRMs are generated. There
are no TL1 responses unless the system is first armed by a TL1 command,
which enables performance monitoring.
SF RAI to SF RAI-CI
Toward Network
See
RAI-CI Toward
Network (RACI)
Option” on page 23
RACI
ENA
Allows a DS1 SF-RAI (yellow alarm) signal received by the H2TU-R to be
converted to an SF-RAI-CI signal toward the network.
DIS
Prevents conversion of the DS1 SF-RAI to SF RAI-CI. It does not prevent SF
RAI-CI to ESF RAI-CI from occurring when FCON is active.
ESF RAI to SF RAI
Overwrite
ROVR
ENA
If the CONV option is set to FCON or ACON, an ESF DS1 payload from the
network with an embedded RAI pattern is converted to an SF-RAI pattern
toward the CI at the H2TU-R.
See
RAI Overwrite
(ROVR) Option” on
page 23
.
DIS
Prevents conversion to an SF-RAI pattern.
H2TU-R DS1 Frame
Conversion
CONV
ACON
Auto (ACON) detection of framing and potential frame conversion at the
remote.
See
Frame Conversion
(CONV) Option” on
page 23
.
OFF
Framing determined by the DS1 frame formatting option.
FCON
Auto detection of framing and forced frame format conversion (FCON) at the
H2TU-R.
Fractional T1 Mode
See
.
FT1
ENA
Enables system response to DDS latching loopback commands for fractional
T1 applications and enables CPE disconnect or trouble indication. See
for LOS/AIS response priorities.
DIS
Disables system response to DDS latching loopback commands for fractional
T1 applications and CPE disconnect or trouble indications.
Continued
Table 6.
H2TU-C-319 List 4E ADC Config Menu Options (Continued)
ADC Config Menu
Options
Front-Panel
Display
Code
Selection
Description