ADC HiGain H2TU-C-319 List 4E - Manual (Page 27)

LTPH-UM-1049-02, Issue 2 Provisioning
H2TU-C-319 List 4E January 9, 2002 19
Power Back Off
Customer PBOC DEF Configures the power output levels of the H2TU-R network unit towards the
network to comply with the Default template as defined in Section 6.1.4.2 of
ANSIT1.E1.4.
ENH Configures the power output levels of the H2TU-R network unit towards the
network to comply with the Enhanced template as defined in Section 6.1.4.2
of ANSIT1.E1.4.
Table 6. H2TU-C-319 List 4E ADC Config Menu Options
ADC Config Menu
Options
Front-Panel
Display
Code
Selection Description
Line Power Feed PWRF OFF Disables powering to the HDSL2 pair.
ON Keeps the HDSL2 line voltage at nominal -185 Vdc.
Remote Provisioning RTPV ENA Enables remote provisioning.
DIS Disables remote provisioning.
Bipolar Violation
Transparency
See “Bipolar
Violation
Transparency
(BPVT) Option” on
page 22
.
BPVT ENA Enables BPVs and HDSL2 CRC errors at the DS1 input to be converted into
DS1 BPVs at the DS1 output at the distant end. This makes HiGain HDSL2
transparent to BPVs.
DIS Disables BPV Transparency.
DS1 BER Threshold
See “DS1 BER
(DBER) Option” on
page 22
.
DBER ENA Enables the fixed 24-hour DS1 BER threshold.
DIS Prevents the generation of a system alarm due to DS1 BER.
HDSL2 BER
Threshold
See “HDSL2 BER
Threshold (HBER)
Option” on page 22
and “System Alarm
Output Pin” on
page 70
.
HBER 1E-6 System alarm relay contact closes and the Status LED flashes red when the
Block Error Rate (BER) exceeds 10
-6 .
1E-7 System alarm relay contact closes and the Status LED flashes red when BER
exceeds 10
-7 .
NONE Prevents generation of a system alarm due to BER.
Special Loopback
Mode SPLB GNLB Configures the HiGain HDSL2 system to respond to the generic in-band
loopback codes.
A2LB Configures the HiGain HDSL2 system to respond to the in-band loopback
codes of the Teltrend addressable repeater.
A3LB Configures the HiGain HDSL2 system to respond to the in-band loopback
codes of the Wescom addressable repeater.
A4LB Configures the HiGain HDSL2 system to respond to the in-band loopback
codes of the Wescom Mod 1 addressable repeater.
SmartJack Loopback LPBK ENA Enables the HiGain HDSL2 system to recognize all in-band SmartJack
loopback commands.
DIS Configures the HiGain HDSL2 system to ignore all in-band SmartJack
loopback commands.
Continued
Table 5. H2TU-C-319 List 4E Standard Config Menu Options (Continued)
Standard Config
Menu Options
Front-Panel
Display
Code
Selection Description