HP Smart Update Manager - Manual (Page 42)

Linux smart-component return codes
Single-target servers:
Meaning Error level
The smart component was installed successfully. 0
The smart component was installed successfully, but the
system must be restarted. 1
The installation was not attempted because the required
hardware is not present, the software is current, or there
is nothing to install. 2
The smart component was not installed. For more
information, see the log file. 3
Multi-target servers:
Meaning Error level
The installation of the deliverable was successful. No reboot
is required. 0
The installation of the deliverable was successful. Reboot
is required for the deliverable to be enabled. 1
The installation was not attempted because the version to
be installed matches the version already installed. 2
The installation was not attempted because of one of the
following: 3
• The version to be installed is older than the version
already installed.
•
The supported hardware is not present, not enabled,
or in a state that an installation could not be attempted.
• The smart component does not support the environment.
•
There is nothing for the component to accomplish.
If the component is being installed to a remote target, such
as an OA or other network-based deployment, this return
code indicates that the target cannot be found. 4
A user canceled the installation before anything could be
installed. 5
The installer cannot run because of an un-met dependency
or installation tool failure. 6
The actual installation operation (not the installation tool)
failed. 7
Linux RPM return codes
Meaning Error level
The Linux RPM installation was successful. 0
The Linux RPM installation failed. 1
42 Using scripts to deploy updates