HP Smart Update Manager - Manual (Page 28)

Table 1 View Firmware Details screen
HP Integrity servers HP ProLiant servers
Bundle version SPP version
iLO version NIC version
Power Monitor firmware version Fiberware version
System firmware version Component versions
FPGA firmware version Bundle version
•
Bundle version
NOTE: The bundle version is only displayed if all four firmware versions match a known
bundle. If there is no known bundle, then HP SUM will display Unknown.
•
iLO firmware version
•
Power Monitor firmware version
•
System firmware version
•
FPGA firmware version
Viewing firmware mismatch details (HP Integrity servers only)
If you have a multi-blade server, you might encounter a situation where you have blades or partitions
that are running different firmware versions. As part of the update procedures, HP SUM will notify
you that there is a firmware mismatch by displaying either Mismatch Found or Mismatch
Found Update Required
. Click the message to go to the View Firmware Details screen, where
you can view the mismatch details. HP SUM will resolve the firmware mismatch when it installs the
new updates.
Installation options
CAUTION: The ability to force the installation of components is generally unnecessary and is not
recommended. Incorrect use could result in data loss or system failure or both.
If you set the installation options from the Review/Install Updates screen, you set these options for
all the targets. If you want to set installation options for specific targets, click Select Bundles or
Select Components for the target, and then click Installation Options for the target.
1.
Click Installation Options.
2. Click Check here to enable force options.
3. Do one of the following:
•
Click Downgrade or Rewrite, depending on whether you want to downgrade the firmware
version, or overwrite the current firmware version.
•
Force upgrade bundles, firmware, or software.
◦ Bundles—Selects older PSP and firmware bundles.
◦ Firmware—Selects older firmware components.
◦ Software—Selects older PSP or software bundles.
NOTE: You cannot use HP SUM to downgrade a Virtual Connect, Ethernet, or
FibreChannel module
28 Using the HP SUM GUI