HP Smart Update Manager (User Guide) User Manual
Page 9
Introduction 9
o
e2fsprogs-32bit
•
For SLES 11 x86 servers:
o
libstdc++33-3.3.3-11.9.i586 or later
o
libnl (required for QLogic and Emulex drivers)
•
For SLES 11 AMD64/EM64T servers:
o
libstdc++33-32bit-3.3.3-11.9 or later
o
libnl (required for QLogic and Emulex drivers)
Minimum requirements for Red Hat Enterprise Linux 6 servers
NOTE:
The following versions listed are needed as a minimum. Later versions of these might be
used as well.
NOTE:
Ensure that each NIC has an IP address assigned. To get the IP address assigned to a
NIC, enter the dhclient command in the console, which enables the NIC interfaces and
retrieves an IP address. If a NIC does not have an IP address, HP SUM appears to hang on start
up.
•
RHEL6 console mode
NOTE:
No X console in either x86 or x86_64 servers. To run HP SUM in silent mode, you must
install the base server with defaults and the following RPMs.
o
lm_sensors-libs-3.1.1-10.el6.
o
net-snmp-libs-5.5-27.el6.
o
net-snmp-5.5.27.el6.
o
kernel-headers-2.6.32-71.el6.
o
redhat-rpm-config-9.0.3-25.el6.noarch.rpm
o
kernel-devel-2.6.32-71.el6.
o
rpm-build-4.8.0-12.el6.
o
gcc-4.4.4-13.el6.
•
RHEL6 graphical mode
NOTE:
If the user elects to install the XWindows support, then the following steps apply to both
x86 and x86_64 servers.
NOTE:
The following items must be the 32-bit version even under x86_64 architecture as HP
SUM and several of the RPMs require 32-bit libraries installed.
o
libuuid-2.17.2-6.el6.i686.rpm
o
freetype-2.3.11-5.el6.i686.rpm
o
libSM-1.1.0-7.1.el6.i686.rpm
o
libICE-1.0.6-1.el6.i686.rpm
o
libXi-1.3-3.el6.i686.rpm
o
libX11-1.3-2.el6.i686.rpm
o
libXext-1.1-3.el6.i686.rpm