HP Smart Update Manager (User Guide) - Manual (Page 15)

Introduction 15
Firmware Types Supported by HP SUM
HP StorageWorks MDS
600 enclosure firmware
Yes
MSA 2000 firmware
(P2x00 firmware)
No
D2600/D2700
firmware Yes when attached through a Smart Array controller
3Gb/s SAS BL switch Yes, online only
FCoE/CNAs Yes, in offline mode only because of FCoE/CNA firmware limitations
Deploying Integrity firmware bundles with HP SUM
You can use HP SUM to deploy components delivered with the Integrity Server Bundles, or use HP SUM to pull
updates from the web. For supported HP SUM versions, see "Support and Limitations of HP SUM (on page
10 )."
Deploying firmware to the HP Integrity Servers, including BL8x0c i2, rx2800 i2 server, and Superdome 2
servers, is done remotely and is the same as deploying other firmware, such as OA, with the following
exceptions:
• You must specify the IP address of the Monarch (primary) iLO-3 MP on the server as the target to be
updated.
• On the Select Items to be Installed screen, click Configure Now, and then select whether you want to
Upload and Activate or Upload but Do Not Activate. The Upload and Activate option automatically
powers down and reboots the server after the update finishes, which activates the firmware. If you select
the Upload but Do Not Activate option, the server does not automatically reboot, so you must either
manually reboot or wait for the next regularly-scheduled maintenance reboot for the firmware to be
activated. The default behavior is Upload but Do Not Activate.
HP SUM supported firmware for HP Integrity servers
Component Supported
Online System ROM firmware Yes
FPGA firmware Yes
iLO-3 MP firmware
Yes
Power Monitor firmware Yes
Superdome 2 firmware Yes
OA firmware Yes
VC firmware
Yes