Canon TX-20 Full Auto Tonometer - Manual (Page 47)

4BasicOperation
47
Sendingdatatoanexternaldevice
If you have set the instrument to send measurements to an external device, the measurement
results are output at this point.
Ifallthemeasurementsareerroneous
The measurement values are neither printed out nor output via RS-232C.
However, the erroneous data is output via LAN.
Stoppingprintingordatatransferinprogress
To stop printing or data transfer in progress, press a button on the operation panel or a soft key on
the monitor panel, measurement button, or alignment off button.
• If you stop printing, the paper is not cut automatically.
• If you stop transferring data, the file after the file being transferred is not sent.
The thermally sensitive paper used for printing may degrade over time. Make a copy of
measurement results to store them for a long period.
6) The measurement unit moves to the right eye.
The Measurement screen changes to the default state. The measured value is cleared and the
LIMITER OFF mark is displayed.
However, you can check the measured value on the DATA screen. When the measurement button
is pressed for the next measurement, the measured value on the DATA screen is also cleared.
7) Repeat the process from "Setup for Patient" to continue measurements with a different patient.
Finishing an Examination
1
Turn off the power switch.
2
Clean the nozzle.
3
Disinfect the forehead rest and the chin rest.
If chin rest paper is being used, change the paper.
4
Put the cap on the nozzle and cover the equipment with the dust cover.
Topackandtransport
Turn on the power in packaging mode (see page 76), let the measurement unit move to the
packaging and transport position, and then turn off the power.
Remove the power cable and remove the cable from any external devices.
L-IE-5191C_TX-20.indb 47 2013/07/18 13:10:29