Canon TX-20 Full Auto Tonometer - Manual (Page 27)

3NamesofParts
27
PATIENT ID Screen
This screen is used to input patient IDs.
9 10 8
7
6
1
2
4
5
3
1 Patient ID area
The text selected from the list of characters
appears in the patient ID input field.
A maximum of 64 ASCII code characters can be
input.
2 ID cursor
Shows the position where the patient ID can be
edited.
3 List of characters
List of characters that can be input for a patient ID.
4 Selection cursor
Select characters to input for a patient ID.
5 ID cursor movement commands
The ID cursor moves in the direction of the selected
arrow.
6 ID delete command
[BS]: Deletes the character that is before the
character specified by the ID cursor. However, if
the ID cursor is specifying the first character, it
deletes that character.
[CLS]: Deletes all the characters in the patient ID.
The confirmation screen is displayed; select one of
the following.
• [OK]: Deletes all text.
• [CANCEL]: Does not delete.
7 Operation reference guide
Shows the types of buttons that can be operated
in the PATIENTID screen. Refer to "5 Types of
Measurements" for operating procedures.
8 MEASURE key*
Press to switch to the Measurement screen.
9 MENU key*
Press to switch to the MENU screen.
10 DATA key*
Press to switch to the DATA screen.
* By doing the settings in advance, if a patient ID has not been input when it is pressed, a message
indicating that the patient ID has not been input is displayed (see page 68).
L-IE-5191C_TX-20.indb 27 2013/07/18 13:10:20