Canon imagePROGRAF iPF610 - Manual (Page 200)

Handling sheets for paper feed slots
Loading Sheets Manually
When using the tray, load the paper in the Top Paper Feed Slot. (→P.186) However, if you have specied
POP Board, insert the sheet in the Front Paper Feed Slot. (→P.189)
Loading paper in the Top Paper Feed Slot
Note
• You can load only one sheet in the Top Paper Feed Slot. Do not load more than one sheet at a time.
This may cause paper jams.
• Store unused paper in the original package, away from high temperature, humidity, and direct sunlight.
• Paper that is wrinkled or warped may jam. If necessary, straighten the paper and reload it.
• Load the paper straight. Loading paper askew will cause an error.
• Before feeding paper or printing, make sure the sheet is at against the Paper Tray Cover . The sheet
may jam if it curls before feeding or printing and the trailing edge drops toward the front.
• If a roll is loaded, rewind the roll before this procedure. (→P.152)
1.
If you send a print job specifying a paper other than POP Board from a computer beforehand,
the type and size of paper are shown on the Display Screen. Press the Load/Eject button.
Note
• If you will load paper before sending a print job, press the Load/Eject button. After a menu for
selection of the type of paper is shown on the Display Screen, press ▲ or ▼ to select the type of
paper, and then press the OK button. Next, a menu for selection of the paper size is shown on the
Display Screen. Press ▲ or ▼ to select the size of paper, and then press the OK button.
2.
Open the Paper Tray Cover (a), and then open the Tray Extension (b).
186 Handling Paper