Register unit telephone number, Select line type, Off-hook alarm – Canon imageCLASS D1350 User Manual
Page 109: Change defaults, Register unit name (fax), Ecm tx, Pause time, P. 6-23)
6-23
U
sing
the
Fax
Func
tions
Register Unit Telephone Number
Register your machine’s fax number.
How to access the option
[
] (Menu)
→
How to register the fax number
Enter up to 20 digits using the numeric keys.
You can also enter the [+].
Select Line Type
Change this option when you cannot send a fax.
Contact your local telephone company when you are not
sure of the line type that you are using.
How to access the option
[
] (Menu)
→
Settings
(Bold: Default setting)
Pulse
Select this setting when you are using a pulse line.
Tone
Select this setting when you are using a tone line.
Off-Hook Alarm
Specify whether to sound an alarm when the telephone
handset is left unhooked and adjust the volume.
How to access the option
[
] (Menu)
→
Settings
(Bold: Default setting)
Off
No alarm sounds.
On
Off-Hook Alarm Volume:
1 to 3
The alarm sounds at the
specified volume.
Change Defaults
Change the default settings, which become effective
when the machine is turned ON and OFF or [
] (Reset) is
pressed.
How to access the option
[
] (Menu)
→ Settings> → Settings See the following section for more information. “Changing the Default Fax Settings” ( Register Unit Name (Fax) Register your name or company’s name (sender’s name). Once the information has been registered, it is printed at the top of each page that you are sending. [ ] (Menu) → Settings> → How to register the sender’s name Enter up to 24 alphanumeric characters. NOTE Where the sender’s name appears on the page The information is printed at the top of each page that you are Sending Date/Time Fax/Telephone Number (FAX No.) Page Number Sender Name (Unit Name) Telephone Number Mark 01/01/2011 02:07 PM FAX 123XXXXXXX CANON P.0001 ECM TX The ECM (Error Correction Mode) detects and corrects errors that occur during fax transmissions. It helps in minimizing sending errors caused by a poor connection. NOTE Check if the ECM is enabled on the receiving fax machine The ECM is effective only when it is enabled on both machines. An error occurs when the ECM is enabled The error may be caused by poor telephone line conditions. When telephone line conditions are poor It may take additional time to send your fax if a problem occurs How to access the option [ ] (Menu) → Settings> → Settings (Bold: Default setting) Off Disable the ECM. On Enable the ECM. Pause Time Press [ ] (Pause) to specify the pause length. For the instructions on how to enter a pause, see “Sending a How to access the option [ ] (Menu) → Settings> → Setting (Bold: Default setting) 1 to 2 to 15 (seconds)
How to access the option
sending.
when sending over the telephone line.