Canon VB-M40 - Manual (Page 48)

4
-18
Image Server
1 [Maximum Number of Clients]
Set the maximum number of clients that can be
connected to the camera at the same time. Up to 30
clients can be set.
If 0 is set, connection is prohibited except for
Administrator.
2 [Camera Control Queue Length]
Set the maximum queue length for clients requesting
camera control privilege from the viewer. The maximum
number is 30. Enter an integer from 0 to 30. If 0 is set,
camera control is prohibited except for the
administrator.
3 [Maximum Connection Time (sec.)]
Set the time in seconds during which an individual
client can connect to the camera. The maximum
number is 65535. Enter an integer from 0 to 65535.
If 0 is set, the connection time becomes unlimited.
4 [Camera Control Time (sec.)]
Set the maximum time during which the viewer can
control the camera. The maximum number is 3600.
Enter an integer from 1 to 3600.
Audio Server
1 [Audio Transmission from the Camera]
When [Enable] is selected, the audio input through the
microphone attached to the camera can be transmitted
to the VB-M40 Viewer.
2 [Input Volume]
Set the volume of input for the microphone connected
to the camera in the range of 1 to 100. The greater the
value, the larger the input volume becomes.
3 [Voice Activity Detection]
If [Enable] is selected, the audio transmission is
stopped temporarily when no audio is output. This way,
the load of the applicable network can be reduced.
4 [Audio Reception from Viewer]
If [Enable] is selected, the audio received from the
bundled RM-Lite Viewer can be output from the
speaker with amplifier connected to the camera.
5 [Output Volume]
Set the volume of output for the speaker connected to
the camera in the range of 1 to 100. The greater the
value, the larger the output volume becomes.
6 [Echo Canceller]
If [Enable] is selected, echo between the microphone
and speaker is suppressed.
7 [Audio Input]
Set the microphone input. Select [Line In], [Microphone
In (dynamic microphone)] or[Microphone In
(condenser microphone)].
[Server]
Image Server, Audio Server and HTTP Server Settings
The following can be set here.
• Image Server
Set the image transmission from the camera.
• Audio Server
Set the audio transmission/reception.
• HTTP Server
Set the authentication method, HTTP port and
web page delivery.
Caution
Switch line in and microphone in on each setting page
according to the specification of the microphone
(P. 4-18).
Using the wrong input may damage the camera and/or
microphone. Be sure to configure settings correctly.
• Audio Transmission
• Input Volume
• Voice Activity Detection
• Echo Canceller
• Audio Reception
• Output Volume