Canon VB-M40 - Manual (Page 39)

4
-9
4
S
et
ting Page
Camera Name
[Camera Name]
Be sure to enter [Camera Name (alphanumeric
characters)].
Up to 15 ASCII characters (spaces and printable
characters) may be used for [Camera Name
(alphanumeric characters)].
Note
• The camera name set here will be shown when the camera is
registered for use with bundled RM-Lite.
Initial Camera Settings
1 [AE Mode], [Slow Shutter], [Shutter Speed]
Set the exposure control and shutter speed for the
camera startup.
[AE Mode]
[Auto]
The exposure is controlled automatically.
[Auto (Flickerless)]
In this mode, image flickers caused by fluorescent
lights, etc., can be reduced. The shutter speed is
automatically adjusted according to the brightness
of the environment in which the camera is used.
[Auto (Shutter-priority AE)]
In this mode, a desired shutter speed can be
specified.
[Slow Shutter]
Slow shutter can be used only if [Auto] is selected in
[AE Mode].
Set the maximum slow shutter time to be used in
auto exposure mode when capturing video in a dark
place. Select [Disable], [1/15] or [1/8]. As longer
shutter times generate residual images when
capturing a moving subject, select an appropriate
time according to the capture conditions.
[Shutter Speed]
Shutter speed can be used only if [Auto (Shutter-
priority AE)] is selected in [AE Mode].
Select a desired shutter speed from the 12 levels
from [1/8] to [1/8000]. When capturing a moving
subject, selecting a higher shutter speed can
reduce blurry image capture.
2 [Exposure Compensation]
The exposure compensation when the camera starts
can be set in the range of -3 to 3. To brighten the
image, set a positive value. To darken the image, set a
negative value.
[Camera] Camera Control and External Device Name Settings
The following can be set here.
• Camera Name
Enter the name of the camera. The camera name
is required for use with RM-Lite.
• Initial Camera Settings
Set the AE mode and shutter speed, exposure
compensation, metering mode, focus mode and
smart shade control and white balance for the
camera startup.
• Camera Control
Set the digital zoom and image stabilizer.
• Day/Night
Set the day/night switching mode.
• Installation Conditions
Set whether or not to use the dome, the LED
setting and image flip.
• Camera Position Control
Set whether or not to limit the pan, tilt and zoom
operations to the preset positions. Also, set the
camera position when nobody has control
privileges.
• External Device Name
Set the external input device name and external
output device name.