Brother NC-7100W - Manual (Page 98)

TCP/IP CONFIGURATION 9 - 4
Using BRAdmin and the TCP/IP Protocol to Set
the IP Address
If your PC is using the TCP/IP protocol, do the following:
1 Select TCP/IP filter in the left frame of the main window.
2 Select the Device menu and choose the Search Active
Devices.
3 Select the Device menu and choose Setup Unconfigured
Device.
4 Select the MAC address of your print server and click the
Configure button.
You can find the node name and MAC address by printing out the
Network Configuration Page. See How to Print a Network
Configuration Page on page A-8 for information on how to print the
Network Configuration Page on your print server.
5 Enter the IP address, Subnet mask and Gateway (if needed)
of your print server.
6 Click OK then select Close.
7 With the correctly programmed IP address, you will see the
Brother print server in the device list.
If the print server is set to its factory default settings without
using a DHCP server, the device will appear as APIPA in the
BRAdmin Professional utility screen.