Brother NC-7100W - Manual (Page 108)

TROUBLESHOOTING 10 - 1
10
10
Troubleshooting
Overview
This chapter describes procedures for troubleshooting problems you
may encounter with a Brother print server, it is divided into the
following sections:
1 Wireless Setup Problems
2 Network Initial Setup Problems
3 Intermittent Problems
4 Protocol-Specific Troubleshooting
Wireless Setup Problems
Before you configure the NC-7100w print server, you need to
temporarily change your computer’s wireless settings to
communicate with the unconfigured print server.
If you are unable to see NC-7100w network (SETUP) in the list when
using Windows
® XP or Mac OS ® X 10.1 to 10.3, check the following:
For more information, refer to the Quick Setup Guide that was
supplied with this product.
1 Move your printer with the print server installed closer to your
PC and try again.
2 Reset the print server back to its default factory setting and try
again. See How to Print a Network Configuration Page on page
A-8 for information how to reset to factory default setting.
3 Follow the steps below according to your operating system
version, Windows
® XP or Mac OS ® X 10.1 to 10.3.
If you are using Windows ® 98/Me, Windows NT ® 4.0 or
Windows ® 2000, please refer to your wireless card manufacture
instructions for changing the wireless settings.