Brother NC-7100W - Manual (Page 58)

CONFIGURING INTERNET PRINTING FOR WINDOWS ® 5 - 6
1 When you get the Local> prompt after connecting to the
console, enter the command:
SET POP3 ADDRESS address
where ipaddress is the address of your POP3 server (consult
with your network administrator if you do not know this address).
2 Enter the command:
SET POP3 NAME mailboxname
SET POP3 PASSWORD emailpassword
where mailboxname is the name of the remote print server
mailbox and emailpassword is the password associated with
this mailbox. Usually the mailbox name is the same as the first
part of the E-mail address that you defined previously (for
example, usually if the E-mail address is [email protected],
then the mailbox name is emailprinter).
3 The print server is set by default to poll the POP3 server every 30
seconds. If you wish to change this value, enter the command:
SET POP3 POLLING rate
where rate is the polling rate in seconds.
Type EXIT to exit the console and save the changes. You have
now completed configuring the print server.
Brother Internet Print: Installing the BIP Software
on Windows
® 95/98/Me/2000/XP and Windows
NT ® 4.0
To install the BIP software on a Windows ® 95/98/2000/XP and
Windows NT ® 4.0 PC, execute the following steps:
■ Be sure that the PC is running an E-mail program (for
example, Microsoft Outlook) that is capable of sending
E-mail message using Winsock.
■ Be sure that your E-mail server is capable of sending
messages across the Internet.