Brother NC-7100W - Manual (Page 77)

6 - 13 NOVELL ® NETWARE ® PRINTING
12 Change context if necessary and select the print queue you
created. Click OK and then OK again, and then exit NWADMIN.
13 Start the appropriate BRAdmin application, and select the
correct print server you wish to configure (by default, the node
names will begin with
BRN_xxxxxx , where xxxxxx is the last
six digits of the Ethernet address (MAC address)).
14 Double click the appropriate print server. You will be prompted
for a password, the default password is
access .
15 Now select the NetWare tab.
16 Select Remote Printer as the Operating Mode, select the
name of your PSERVER NLM as the print server Name and
select the number of the printer from step 6 as the Printer
Number.
17 Click OK. And exit BRAdmin.
You can find the NetWare ® server name and MAC address
by printing out the Network Configuration Page. See How to
Print a Network Configuration Page on page A-8 for
information on how to print the Network Configuration Page
on your print server.
The same service assigned by NetWare ® print server cannot
be used for both queue server mode and remote printer
mode. If you want to enable remote printer capabilities on a
service other than the default NetWare
® service, you must
define new services that are enabled for NetWare ® and for
the desired port.