Brother MFC-8950DWT - Manual (Page 48)

41
Configuring your machine for a wireless network (For MFC-8710DW, MFC-8810DW, MFC-8910DW and MFC-8950DW(T))
3
For Touchscreen models
3
a Press Menu.
b Press Network.
c
Press WLAN.
d
Press a or b to display WPS w/PIN Code, and then press WPS w/PIN Code.
e
When WLAN Enable? is displayed, press On to accept.
This will start the wireless setup wizard.
To cancel, press Stop/Exit.
f The LCD will show an 8 digit PIN and the machine starts searching for an access point.
g Using a computer that is on the network, type “http://access point’s IP address/” into your browser.
(Where “access point’s IP address” is the IP address of the device that is used as the Registrar
1
.) Go to
the WPS setting page and input the PIN which the LCD shows in f to the Registrar and follow the
on-screen instructions.
1 The Registrar is normally the WLAN access point / router.
Note
The setting page is different, depending on the brand of access point / router. See the instruction manual
supplied with your access point / router.