Brother MFC-8950DWT User Manual
Page 118
111
LDAP operation (DCP-8250DN, MFC-8810DW, MFC-8910DW and MFC-8950DW(T): standard, MFC-8510DN, MFC-8520DN and
MFC-8710DW: available as a download)
6
For Touchscreen models
6
a
Press
to search.
b
Enter initial characters for your search by using the buttons on the LCD.
Note
• You can enter up to 15 characters.
• For information on how to enter text: uu Basic User's Guide.
c
Press OK.
The LDAP search result will be shown on the LCD with
before the local address book search
result.
If there is no match on the server and the local address book, the LCD will show
Results cannot be found.
for about 60 seconds.
d
Press a or b to scroll until you find the name you are looking for.
To confirm the details of the name, press Detail.
e
If the result includes more than one fax number or E-mail address, the machine will prompt you to choose
either a fax number or an E-mail address.
Do one of the following:
For fax and I-Fax sending operations, press OK and go to step f.
For Scan to E-mail server sending operations, go to step g.
f
Press Send a fax.
g
Load your document and press Start.
Note
• The LDAP function of this machine supports LDAPv3.
• You may need to use Kerberos Authentication or Simple Authentication to connect to your LDAP server,
depending on the security policy set by your Network Administrator.
You must configure the SNTP protocol (network time server), or you must set the date, time and time zone
correctly on the control panel for Kerberos Authentication. (For information about setting SNTP, see
Synchronize with SNTP server uu page 98. For information about setting the date, time and time zone:
uu
Quick Setup Guide.)
• SSL/TLS is not supported.
• For more information, visit us at.