Brother MFC-8950DWT - Manual (Page 18)

11
Configuring your machine for a wireless network (For MFC-8710DW, MFC-8810DW, MFC-8910DW and MFC-8950DW(T))
3
Confirm your network environment
3
Connected to a computer with a WLAN access point/router in the network
(Infrastructure mode)
3
1 WLAN access point/Router
1
1 If your computer supports Intel ® MWT (My WiFi Technology), you can use your computer as a WPS (Wi-Fi Protected Setup) supported access
point.
2 Wireless network machine (your machine)
3 Wireless capable computer connected to the WLAN access point/router
4 Wired computer which is not wireless capable connected to the WLAN access point/router with a
network cable
Configuration method
3
The following instructions will offer four methods for configuring your Brother machine in a wireless network
environment. Choose the method you prefer for your environment.
 Wireless configuration temporarily using a USB cable (Recommended)
See Wireless configuration temporarily using a USB cable (Recommended) uu page 13.
 Wireless configuration using the Setup Wizard from the control panel
See Configuration using the machine’s control panel Setup Wizard uu page 18.
 One push wireless configuration using WPS (Wi-Fi Protected Setup) or AOSS™
See One push configuration using WPS (Wi-Fi Protected Setup) or AOSS™ uu page 35.
 PIN Method wireless configuration using WPS
See Configuration using the PIN Method of WPS (Wi-Fi Protected Setup) uu page 38.
2
1
4
3