Brother MFC-8950DWT - Manual (Page 39)

32
Configuring your machine for a wireless network (For MFC-8710DW, MFC-8810DW, MFC-8910DW and MFC-8950DW(T))
3
Note
• If you configure your machine using EAP-TLS Authentication, you must install the Client Certificate issued
by a CA before you start configuration. Contact your network administrator about the Client Certificate. If
you have installed more than one certificate, we recommend you write down the certificate name you want
to use. For installing the certificate, see Using Certificates for device security uu page 132.
• If you verify your machine using the Common Name of the Server Certificate, we recommend you write
down the Common Name before you start configuration. Contact your network administrator about the
Common Name of the Server Certificate.
b Press Menu.
c Press Network.
d Press WLAN.
e Press Setup Wizard.
f When WLAN Enable? is displayed, press On to accept.
This will start the wireless setup wizard.
To cancel, press Stop/Exit.
g The machine will search for your network and display a list of available SSIDs.
You should see the SSID you wrote down earlier. If the machine finds more than one network use a or
b
key to choose your network. Go to step k.
If your access point is set to not broadcast the SSID, you will have to manually add the SSID name. Go
to step h.
h Choose using a or b.
Go to step i.
i Enter the SSID name. (For information on how to enter text: uu Quick Setup Guide.)
Press OK. Go to step j.
j Choose Infrastructure when instructed.