PNI TCM - Manual (Page 28)

PNI Sensor Corporation DOC#1014688 r06
TCM User Manual – July 2013 Page 23
6.2.3 Changing Modules
Once a connection has been made, TCM Studio will recall the last settings. If a different
module is used, click the button once the new module is attached. This will
reestablish a connection, assuming the module baud rate is unchanged.
6.3 Configuration Tab
Note: No settings will be changed in the module until the button has been selected.
6.3.1 Mounting Options
TCM Studio supports 16 mounting orientations, as illustrated previously in Figure 4-2.
The descriptions in TCM Studio are slightly different from those shown in Figure 4-2,
and the relationship between the two sets of descriptions is given below.