PNI TCM - Manual (Page 27)

PNI Sensor Corporation DOC#1014688 r06
TCM User Manual – July 2013 Page 22
6.2 Connection Tab
6.2.1 Initial Connection
If using the PNI dual-connectorized cable, ensure the batteries are well-charged.
Select the serial port the module is plugged into, which is generally COM 1.
Select 38400 as the baud rate.
Click the button if the connection is not automatic.
Once a connection is made the “Connected” light will turn green and the module’s
firmware version, serial number, and PCA version will be displayed in the header section.
6.2.2 Changing Baud Rate
To change the baud rate:
In the Module window, select the new baud rate for the module.
Click the button. The button will change to read .
In the Computer window, select same baud rate for the computer.
Click the button. The button will revert back to .
Note: While the TCM can operate at a baud rate of 230400, a PC serial port normally will not
operate this fast.