PNI TCM - Manual (Page 16)

PNI Sensor Corporation DOC#1014688 r06
TCM User Manual – July 2013 Page 11
4.3.2 Mounting Orientation
The TCM can be mounted in various orientations, as shown for the TCM XB in Figure
4-2. All reference points are based on the white silk-screened arrow on the top side of the
board. The orientation should be programmed in the TCM using TCM Studio or the
kSetConfig command. The default orientation is “STD 0°”.
Note: TCM XB is shown. The Z axis sensor and the connector are on the module’s top surface,
regardless of model.
Figure 4-2: Mounting Orientations