FUTEK IPM52x (D520) Digital Display User Manual

Page 30

• Reset the meter to the user defined defaults

"DEFAUL" default program prompt

"YES"/"NO" "No" to exit this menu

"Yes" if one of the 3 defaults is to be
done. Continue to next step

"USEr"/"Fac"

• "FAC" (factory) allows the reset of the

meter back to factory defaults. When the
prompt
i) "FacTrY" is displayed, the SELECT

key must be pushed and held ( 10
seconds) until the prompt "dONE"
and returns to "SPEC" branch. If any
other key is push it will abort the
default operation and return to
"SPEC" branch.

• "Usr" (User) allows the setup of custom

defaults or default to the custom defaults
j) "StorE" allows the custom defaults

to be set. This will set the defaults to
the setup of the meter it is currently
programmed.

• "SET df" When this is

displayed the SELECT
key must be pushed and
held until the "dONE"
prompt. Meter then
returns to "SPEC" branch
heading.

• "GET df" When this is

displayed the SELECT
key must be pushed and
held until the "dONE"
prompt. This takes
approximately 10
seconds. Meter then